When Using The Unit; Removing The Collected Water - Kunft KDH2775 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

circulation.
below   5º   C   (41º   F).   The   coils   can   become   covered   with   frost   at  
temperatures  below  5º  C  (41º  F),  which  may  reduce  performance.
valuables.
damage.
effective.
Casters
(Install  at  four  points  on  the  bottom  of  the  unit)
water  in  the  bucket.  (The  unit  may  tip  over  and  spill  water.)
NOTE:  Casters  are  optional,  some  models  do  not  include  them.

When using the unit

hours.
5º  C  (41º  F)  and  35º  C  (95º  F).
quickly,  allow  approximately  three  minutes  for  the  correct  operation  
to  resume.
also  being  used  for  other  electrical  appliances.
electrical  outlet.
nameplate   located   on   the   side/rear   of   the   unit)   electrical   socket  
outlet  with  earth  connection.
not  operate  properly.

Removing the collected water

There  are  two  ways  to  remove  collected  water.
1.  Use  the  bucket
16
dehumidifier
and  carefully  pull  out  straight  so  water  does  not  spill.  Do  not  put  the  
Otherwise  the  bucket  will  fall  and  cause  the  water  to  spill.
position.
NOTES:
unit.  Doing  so  may  damage  the  product.
the   bucket   against   anything   or   failing   to   push   it   in   securely   may  
cause  the  unit  not  to  operate.
1.     Pull  out  the
2.     Hold  both  sides  of  the  
bucket  a  little
bucket  with  even  strength,  
and  pull  it  out  from  the  unit.
Fig.  5
Fig.  6
2.  Continuous  draining
the  unit  as  shown  in  Fig.8.  Attach  the  water  hose  to  the  drain  hose  
outlet   o f   t he   u nit.   M ake   s ure   t he   c onnection   o f   t he   w ater   h ose   a nd   t he  
drain  hose  outlet  of  the  unit  is  tight  and  does  not  let  the  water  leak.
facility.  The  drainage  facility  should  be  lower  than  the  drain  outlet  
of  the  unit.
Fig.9a  and  Fig.9b.
NOTE:  When  the  continuous  drain  feature  is  not  being  used,  remove  
the  drain  hose  from  the  outlet  and  attach  the  rubber  plug  back  into  
the  drain  outlet.
EN
KDH2775
3.     Pour  the  water
out.
Fig.  7
17
Tabla de contenido

Solución de problemas

loading

Tabla de contenido