Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To set the torque, screw or unscrew the lock nut. Then the
removing steel ring can be fixed by a grain* taking care of
it in the appropriate grooves.
* grain not included in delivery
FRONT PANEL LIGHTS AT STATION:
On the front panel you can also see 3 lights: the green one
(POWER) will light permanently when the power is on; the
yellow one (TORQUE) will light only when the torque has
been reached and the red one (ERROR) will light only when
the torque is not correct (screw closed or torque reached
during the RAMP time).
The temperature of the unit can normally reach 45°C.
ATTENTION :
On the back panel you can find a socket equipped with a
fuse holder and on/off switch. To replace the fuse just pull
out the fuse holder and change the fuse.
Always remember to switch off the control unit at the end
of each working shift.
To check the torque value we suggest the use of WTT5
torque tester.
6. Maintenance
The WTS control unit and the WBTS screwdrivers are
maintenance free
NOTE
The sound level generated by WELLER electric screwdrivers
is always lower than 55 dB(A).
The vibrations transmitted to operator's hand are lower
than 2.5 m/s². In particular the exposition to vibrations is
lower than 1 m/s² for operators who make up to 4200
screwing cycles per day.
7. Warranty
Claims based on defects will fall under the statute of
limitations 12 months after delivery to the purchaser of the
goods. This shall not apply to rights of recourse of the
purchaser according to sections 478, 479 German Civil
Code. We shall assume liability for warranties supplied by
us only if the quality guarantee or service warranty has
been submitted in writing and using the term "Warranty".
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.
English
4
Tabla de contenido
