Assembly - CHAMBERLAIN Power Drive 3132E FS2 Manual Del Propietário

ASSEMBLY STEP 1
For Sliding and Swinging Gates ONLY
Assemble the Rail and
Attach the Cable Pulley Bracket
To avoid installation difficulties, do
not run the garage door opener until
instructed to do so.
1. Align the four rail sections on a flat
surface exactly as shown. Center
sections are interchangeable. Front
and back sections are also
interchangeable for ease of

assembly.

2. Connect the center sections and the
1/4" lock nuts to the end sections from
the same side, as shown.
NOTE: If rail is not assembled exactly as shown,
trolley will not travel smoothly along length of rail or it
will hit against nuts.
3. Insert the carriage bolts from the opposite side of the
end sections. Tighten the nuts. When assembled, rail
has a front-to-back position as shown.
4. Position the cable pulley bracket on the front end of
the rail as shown. Fasten securely with the hardware
provided.
NOTE: When tightening the bolts be sure to keep
bracket parallel to the rail. Otherwise, the rail may
bow when the opener is operated.
Brace
Rail
(End Section)
Rail connects to
opener at this end.
HARDWARE
SHOWN ACTUAL SIZE
Hex Bolt
5/16"-18x7/8"
Square Carriage
Bolt Hole
1/4" Lock Nut
Carriage Bolt
1/4"-20x1/2"
Rail
(Center Section)
10
Carriage Bolts
Lock Nut
1/4"-20x1/2"
1/4"-20
Lock Washer
Nut
5/16"-18 5/16"
Cable pulley bracket
attaches to this
end of rail.
AWAY FROM
OPENER
Rail
(End Section)
Hex Bolts
5/16"-18x7/8"
Lock Washer
5/16"
Nut
5/16"
Cable Pulley
Bracket