Installation Of The Outdoor Unit - ascon IM-5MSY-1009-ACSON Manual De Instalación

• The outdoor unit must be installed in such a way, so as to prevent short circuit of the hot discharged air or obstruction to
the smooth air fl ow. Please follow the installation clearance shown in the fi gures below. Select the coolest possible place
where intake air temperature is not greater than the outside air temperature (maximum 45°C/113°F).
• Where a wall or other obstacle is in the path of outdoor unitʼs intake or exhaust airfl ow, follow the installation guidelines
below.
• For any of the below installation patterns, the wall height on the exhaust side should be 1200mm or less.
Wall facing one side
More than 100
• Before installing the piping and connecting cord, please remove the access panel and plastic valve cover for easy access.
Refer to fi gures shown below.
• There are 2 holes on the base of Outdoor Unit for
condensed water to fl ow out. Insert the drain elbow to one
of the holes.
• To install the drain elbow, fi rst insert one portion of the
hook to the base (portion A), then pull the drain elbow in
the direction shown by the arrow while inserting the other
portion to the base. After installation, check to ensure that
the drain elbow clings to base fi rmly.
• If the unit is installed in a snowy and chilly area, condensed
water may freeze in the base. In such case, please remove
plug at the bottom of unit to smooth the drainage.
1 IM 5MSY-1009(1)_EN.indd 05 1 IM 5MSY-1009(1)_EN.indd 05
All manuals and user guides at all-guides.com

INSTALLATION OF THE OUTDOOR UNIT

More than 350
1200
or less
Side View
PLEASE REMOVE
ACCESS PANEL &
PLASTIC VALVE
COVER WHEN
CONNECTING
THE PIPING AND
CONNECTING
CORD.
PUSH & PULL UP
! CAUTION
Do not install the unit at altitude over 2000m for both indoor and outdoor
Wall facing two sides
More
than 100
More than 50
Top View
Wall facing three sides
More than 100
More than 350
More than 50
Top View
Plug
A
BASE
DRAIN
ELBOW
1-5
More than 350
More than 50
Unit : mm
DRAIN
ELBOW
1/7/10 3:57:14 PM 1/7/10 3:57:14 PM