ABB Thomas & Betts Elastimold 655LR Instrucciones De Instalación página 4

IS- - 0249
March 2016
Page 4 of 10
STEP 9
Push elbow onto mating part, lining up the hole in the
compression lug with the stud on the mating part.
STEP 10
Clean and lubricate the mating part for the opposite end of
the elbow. Insert the mating part into the elbow. Engage
the threads and hand tighten. Torque mating part
according to the instructions supplied with the mating part.
Elbow
Connector
Tap Plug
Plug
Clean
Clean
&
&
Lubricate
Lubricate
Clean & Lubricate
STEP 12
Insert one end of a piece of wire with ampacity at least
equivalent to No. 14 AWG Copper through the grounding
eye and twist to make a small loop. Do Not damage the eye.
Connect wire to ground using a suitable connector.
The shield of the cable must be grounded. Ground
according to the instructions supplied with the grounding
device. If no grounding device is used, the shield must be
grounded through an alternate method.
It is also recommended that the jacket of the cable be
waterproofed at this point to prevent moisture from
entering the cable.
STEP 13
When constructing 600amp L--Kits be sure to tighten each component to specified torque per instructions
CAUTION:
provided.
Reducing
Tap Plug
Reducing
Basic
Insulating
Plug
Clean
&
Lubricate
STEP 11
If an insulating plug is used as a mating part, clean and
lubricate inner surface of the voltage detection cap and
place on elbow. Push down hard until cap snaps into place.
Follow voltage test directions below.
Tap Well
Clean &
Lubricate
From Grounding
Device or Cable Shield
Capacitive Test Point
Ground Eye
Connection Wire
To Ground