Idiomas disponibles
Idiomas disponibles
Hydraulic Foot Pump, 700 Bar
SPECIFICATIONS
2 step pressure rating:
1st stage 13.8 bar
2nd stage 700 bar
Usable oil capacity: 700 ccm
Oil volume per stroke:
1st stage 13.0 ccm
2nd stage 2.8 ccm
Oil port thread: 3/8 NPT
Hose length: 2.5 m
In case of improper use of the hydraulic unit, the hydraulic forces released can result in
damage to property and serious injuries.
Would you therefore please familiarise yourself with the operation and observe the following
instructions:
Always keep an eye on the device during operation.
Discontinue operating the hydraulic unit if it is not working correctly.
Make sure to avoid injuries to the hands due to trapping.
Never reach inside the hydraulic unit and make sure to keep sufficient distance.
Always wear by all means protective glasses and safety gloves on operating the hydraulic
unit.
Make sure the hose couplings are firmly in place and tightened.
Avoid contact of the skin and the eyes with high pressure oil.
Should any high pressure oil reach the eyes or wounds, remove the oil at once and
consult a doctor without immediately.
Check hose lines and equipment for damage before and after each use.
In case the hose lines, hose couplings or the hydraulic unit are defective, the device must
not be used before completion of repairs.
Do not remove any nameplates / warnings, which must be easily visible / clean remain on
the ramps.
Always enclose these directions for use when you leave the equipment to third parties.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
BGS 1613
