Blue Rabbit 2.0 Belvedere Instrucciones De Montaje página 6

TOOLS REQUIRED
(1) ratchet spanner with cap 13
(2) tape measure
(3) pencil
(4) bit torx TX20
(5) bit torx TX30
(6) bit torx TX40
(7) drill and/or screwdriver
(8) square
(9) wood bore bits Ø 3 and Ø 5 mm
(10) speed bore bits Ø 10 and Ø 28 mm
(11) wood saw
(12) hammer
(13) sandpaper
WOOD SCREWS
step 1/ To prevent the wood spli ng we recommend pre-drilling all wood to be
screwed. Always drill at least 15 mm less deep than the length of the screw.
drill wood screws with a diameter of 4.5 mm with a 3 mm wood bore bit.
step 2/ First turn the screw one or two millimetres into the plank to be secured,
then press this firmly against the other piece of wood.
step 3/ Tighten the screw with the torx TX20 bit supplied in the wood un l the
head of the screw is level with the surface of the wood.
COACH SCREWS
step 1/ To prevent the wood spli ng we recommend pre-drilling all wood to be
screwed. Always drill at least 15 mm less deep than the length of the screw.
Pre-drill coach screws with a diameter of 8 mm with a 5 mm wood bore bit.
step 2/ Place the flat washer and the bo om of the protec ve cap over the sha
of the screw.
step 3/ First turn the screw one or two millimetres into the beam to be secured,
then press this firmly against the other piece of wood.
step 4/ Tighten the screw with the torx bit TX40 supplied.
step 5/ Press the top of the protec ve cap into the opening provided.
BOLTED CONNECTIONS
step 1/ Drill a hole with diameter 10 mm through both planks or beams that have
already been screwed together (see 'wood screws')
step 2/ Hit the drive-in nut with a hammer along the designated side of the beam
in the hole.
step 3/ Place the spring ring, the flat washer and then the bo om part of the
protec ve cap over the sha of the bolt.
step 4/ Push the bolt through the hole, and turn by hand several mes un l the
bolt turns smoothly in the press-in nut.
step 5/ Tighten the bolt with torx bit TX40 supplied, un l the spring ring is fully
fla ened between the head of the bolt and the flat washer.
step 6/ Press the top of the protec ve cap into the opening provided.
6
EN ASSEMBLY INSTRUCTIONS
Pre-
13
(1) (2) (3)
30 40
TX TX
(5) (6) (7)
3 5 10
(9) (9) (10)
(11) (12) (13)
TX 20
(4)
(8)
28
(10)
TX TX 20 30
3
40
5 TX
TX 40
10