LUND 86521217 Instrucciones De Instalación página 3

PROCEDURE:
REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. CUTTING MAY BE REQUIRED. INSTALLATION MAY INTERFERE WITH FRONT
MOUNTED SENSORS. NOTE: It may be necessary to remove/relocate front license plate and license plate
bracket. It is not required, but strongly recommended. If local/state law requires a front license plate, a license
plate relocation kit is available.
1. Start installation from under the front of the vehicle. Determine if the vehicle is equipped with tow hooks.
IMPORTANT: Tow hooks cannot be reinstalled with the Bull Bar.
Tow Hook equipped vehicles:
a. Remove the factory tow hook from the end of each frame channel, (Figures 1—3).
b. Select the passenger/right Mounting Bracket. Insert the bracket through the opening in the bumper
and up to the frame. Trim the plastic as required to clear the bracket, (Figure 5). Repeat to check for
clearance on driver/left side of bumper.
c. Proceed to Step 2.
Vehicles without tow hooks:
a. Cut out the indented area in both sides of the plastic bumper insert to clear the brackets as pictured,
(Figures 4 & 5). IMPORTANT: Make several small cuts for best fit.
b. Check for clearance between brackets and opening and trim the plastic as required to clear the
brackets.
2. Line up the holes in the bracket with the holes in the end of the frame channel for the tow hook, (Figure
5). Select (1) Double Bolt Plate, (Figure 6). Insert the bolt plate into the end of the frame and out through
the (2) holes in the side of the frame and out through the bracket, (Figures 6 & 8). Secure the bracket to
the bolt plate with (2) 12mm Flat Washers and (2) 12mm Nylon Lock Nuts. Leave hardware loose at this
time.
3. Repeat Step 2 to install the Single Bolt Plate, (Figure 9), into the single forward tow hook mounting hole in
the other side of the frame channel and Bracket, (Figures 6, 10 & 11).
4. Repeat Steps 2 & 3 to install the driver/left Mounting Bracket.
5. With assistance, hold the bull bar up in position on the outside of the mounting brackets. Attach the bull
bar to the brackets with the supplied bolt assembly's (4). Do not tighten hardware at this time.
6. Check the bull bar alignment with the vehicle and for clearance between the bull bar and the bumper.
Adjust as required then fully tighten all hardware at this time.
7. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment: We recommend using Mild soap to clean the Bull Bar.
Page 2 of 5
I-Sheet Number 20262 Rev.B
REVOLUTION BULL BAR
2019+ CHEVY SILVERADO 1500
01/04/19 (DP)