HH Electronics TRE-1201 Manual Del Usuario página 4

TENSOR SERIES ACTIVE LOUDSPEAKER
REAR PANEL CONTINUED
7. MAINS INLET SOCKET AND FUSE: IEC input
for connection of an appropriate mains lead. Only replace
the fuse with the type indicated on the rear panel.
8. MAINS SWITCH: Turns the system on and off.
Ensure the Volume controls
switching on and off.
9. VOLTAGE SELECT SWITCH: Although every
effort has been made to select the correct voltage for
the region of use. Please check the voltage setting is
correct before powering up for the first time.
Damage could occur if the voltage is incorrectly
set. See below for more information.
10. INFORMATION: Area relating to the amplifier:
Serial Number, operational information, power rating,
etc.
11. AIR VENTS: These are critical for the longevity
and reliability of the amplifier - DO NOT BLOCK. The
same applies to the vents at the top of the control
panel.
FUSE REPLACEMENT AND VOLTAGE SELECTION
SWITCH OFF AND DISCONNECT THE POWER CORD BEFORE PROCEEDING.
POWER
© 2020 HH Electronics Ltd
is set to minimum when
FUSE REPLACEMENT
1. Slide out the fuse holder tray.
2. Only replace fuse with the same
type and power rating as specified
on the rear panel.
Designed and Engineered in the UK by HH Electronics LTD.
DESIGNED AND ENGINEERED IN THE UK
7
10
MODEL: TRE-1201
WWW.HHELECTRONICS.COM
VOLTAGE SELECTION
110-120V SETTING
220-240V SETTING
Using a suitable tool, slide the voltage
selector switch to the required
operating voltage.
8
9
11
4