SPX EF-7701 Manual Del Usuario página 52

MANUAL- ENGLISH
WIRING OF THE RECEIVER
Yellow wire - connect to 12V- 24V power
Gray wire – connect to DOWN solenoid
White wire – connect to UP solenoid (not used on KRC11 and KRC12)
Orange wire – connect to motor start solenoid
Black wire – connect to ground
PLACEMENT OF THE RECEIVER
Mount the receiver [on the frame of the hydraulic lift equipment] with the
connector facing downward and close to the unit's power source or unit.
Select a location, if possible, which is protected from the wind and weather.
!! Avoid locations where the receiver may be exposed to abnormal moisture
conditions, i.e. during high pressure washing.
!! Avoid locations close to metal objects, inside metal objects, electrical
cables and antennas, this may cause the RF signal to be weak and not
operate the unit. [Provide the receiver with separate wiring to the power
source.]
NOTE: Upon delivery the receiver will be pre-wired. DO NOT ATTEMPT TO
MODIFY THE WIRING. ANY MODIFICATIONS TO THE WIRING WILL
INVALIDATE SPX's WARRANTY ON THE PRODUCT.
HOW TO PROGRAM THE RECEIVER FOR A REPLACEMENT OR NEW
TRANSMITTER:
RF remote receivers are shipped from the factory programmed to a specific
transmitter. To program the receiver for a new or replacement transmitter
you must first clear the receiver's memory:
1.) Apply power to the receiver. The LED on the receiver will flash RED four
times. This indicates that the receiver has power.
2.) Place a fairly powerful magnet over the receiver "learn" area (see Figure
1 for location) and hold it there. The LED should illuminate and go to a
constant RED state. (if you can't get a response from the LED, try placing the
magnet on the back or to the side of the unit's enclosure in the same general
area) Once the LED is on, continue to hold the magnet by the area until the
RED LED goes out. (approximately 15 seconds) Once the LED goes out, the
receiver's memory is cleared
© SPX Corporation 2011 Page 4 of 6 SPX# 1000499rev0