Assembly Instruction - Humanscale M/Connect 2 Guia Del Usuario

Ocultar thumbs Ver también para M/Connect 2:
Tabla de contenido

Assembly Instruction

Installing M/Connect onto Edge of Table
Caution: Maximum weight load of M/Connect is as follows:
M2.1: 15.5 lbs. M8.1: 28 lbs. M10: 40 lbs. M/Flex: 60 lbs.Total.
M10 is not to be used on M/Flex when mounted to MConnect2
Do NOT exceed maximum weight limits.
When used in conjunction with M/Connect 2, M/Flex post must be limited to 24 inches
Optional: Install USB-C Cable Retaining Clip
Turn M/Connect upsi
1
Screw cable retaining clip into sheet metal base
Place M/Connect Clamp onto Table
1
Slide mount against work surface edge and
fully tighten clamp screw (fig. A)
Installing M/Connect Through A Grommet
Hole or System Furniture
Disassemble Clamp
1
Remove the two screws (fig. B) using hex key (fig. D) and detach the
smaller clamp bracket (fig. C) from the larger bracket
de down to a
ccess screw hole
A
C
B
D
5
Tabla de contenido
loading

Tabla de contenido