Procedures; Getting Started; Checking The Tape Drive - Tandberg Data SDLT 220 Guia De Inicio Rapido

P r o c e d u r e s

Getting Started

This guide describes how to install your tape drive. To get started:
a.
Inspect the contents of the box.
If items are damaged, contact your tape drive provider.
b.
Verify that the enclosed cable is compatible with the SCSI connector
on the host computer.
c.
Confirm that the host computer's SCSI controller card matches the
tape drive's SCSI interface: single-ended, low-voltage differential
(LVD), or high-voltage differential (HVD).
A single-ended drive will not work with an HVD controller card,
and vice versa.
d.
Verify that the backup software and operating system are compatible
with the new drive.
Visit www.dlttape.com for current compatibility information.
For more information about compatibility, refer to the
SDLT 220 and SDLT 320 User Reference Guide.

Checking the Tape Drive

To check that the tape drive works and is not damaged:
a.
Connect the power cord to the tape drive and plug it into an AC
power source.
b.
Power on the tape drive using the switch on the back the drive.
c.
Monitor the tape drive's Power-On Self-Test (POST) behavior and
messages displayed on your computer screen.
For more information about POST messages, refer to the
SDLT 220 and SDLT 320 User Reference Guide.
d.
Power off the tape drive and unplug it from the AC outlet.
All manuals and user guides at all-guides.com
For more information:
Refer to the documents on the
enclosed CD-ROM, or visit
www.tandberg.com.
For help installing the tape
drive:
Contact Tandberg Technical
Support at +49-231-5436-142.
3
On/Off Switch
Getting Started
•
1