Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8 > User guide / Maintenance
Connection:
For connection of the pressure gauge to a scuba regula-
tor first stage, connect the high pressure gauge to the HP
port of the regulator 7/16x 20 UNF port. Lubricate the o-
ring on the hose connection prior to mounting. Using a
suitable wrench torque the fitting until tighten. Do not
over torque. Mount the scuba regulator on a pressurize
scuba cylinder, open the valve slowly until the gauge is
pressurized and check for leaks. Do not use if leaks are
detected.
WARNING :
The pressure gauge is manufactured for use only
with Compressed Air for scuba diving only. Do
Not use with Enriched Air diving Nitrox or pure
Oxygen. For Enriched Air diving Nitrox use dedi-
cated Nitrox equipment.
Avoid any direct impact on the gauge housing or
dial cover. Do not allow water to enter the
connection port or hose.
Maintenance
After each use rinse with fresh water.
Dry away from direct sun light or heat.
Store in a dry cool place.
Do not carry the regulator system by the high pressure
hose. Have the connection and pivot o-rings replaced
annually by a Beuchat authorized dealer. Lubricate the
hose and fittings with approved lubricant for scuba servi-
ce. Inspect the High Pressure hose periodically before
each use. Replace every two years or when required as
needed upon inspection or when leaks are detected.
Tabla de contenido
