Tabla de contenido
Idiomas disponibles
Idiomas disponibles
!
Positioning the probe:
For optimum probe reading, position it perpendicular to the tubing (probe cable extracted upward).
!
The probe's angle of inclination must never exceed 45° from vertical.
Electrical wiring:
Connect the power supply cable to the mains and the servocontrol pre-wired cable to the auxiliary
contact of the filter box (230 Vca)
Set Point adjustment
Keep the
key pressed down and set the desired value using the
and
keys.
Press the
and
keys
(simultaneously) for 5 seconds to
enter the SETUP programme
Block or authorise calibration using
the
key
Press the
key to progress to the
Flow
light (
4)
see page
Wire Connection:
1) Input Redox Probe
2) Input Temperature Probe (PT100)
3) Input Level Probe (Product Tank
4) Input Flow Rate (High Voltage 230 Vac)
5) Output Relay Alarm remote (Dry contact, Relay
250 Vac 10 A)
6) Output Relay Drive Solenoid Valve (Dry contact,
Relay 250 Vac 10 A)
7) Power Supply 230 Vac
8) Switch Power Supply
0000136865
All manuals and user guides at all-guides.com
Adjustment (Setup)
Choose the Redox measurement
scale using the key
Press the
key to progress to the
OFA
light
(see page 4)
Block or authorise the Flow function
using the
key
rev. 6.0
Press the
key twice to progress
Cal
light
to the
Block or authorise the OFA alarm
using the
key
Confirm and exit the adjustment
Confirm and exit the adjustment
menu using the
key
2
Tabla de contenido
