RISCO Group RP512MD2400A Instrucciones De Instalación página 7

FCC Part 68 Note:
1. This equipment, Fast PSTN modem (RP128MD2400A) complies with Part 68 of the FCC Rules and the
requirements adopted by the ACTA. On the bottom panel of this equipment is a label, that contains
among other information, a product identifier in the format US:RISAL10BMD2400. If requested, this
number must be provided to the telephone company.
2. This equipment is designed to be connected to the telephone network using a terminal block which is
Part 68 compliant and properly installed RJ31X connector. See Installation Instructions for details.
3. The REN is used to determine the number of devices that may be connected to a telephone line.
Excessive RENs on a telephone line may result in the devices not ringing in response to an incoming
call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to a line, as determined by the total RENs, contact the local
telephone company. The REN of alarm system is part of the product identifier that has the format
US:RISAL10BMD2400.
4. If the Fast PSTN modem causes harm to the telephone network, the telephone company will notify
you in advance that temporary discontinuance of service may be required. If advance notice is not
practical, you will be notified as soon as possible. Also, you will be advised of your right to file a
compliant with the FCC if it is necessary.
5. The telephone company may make changes in its facilities, equipment, operations or procedures that
could affect the operation of the equipment. If this happens the telephone company will provide
advance notice in order for you to make necessary modifications to maintain uninterrupted service.
6. If trouble is experienced with the Fast PSTN modem for repair or warranty information please contact
Rokonet Industries USA Inc 2822 NW 79th Ave. Miami, Florida 33122 USA, phone number 305 592
3820, URL: [email protected].
If the equipment is causing harm to the telephone network, the telephone company may request to
disconnect the equipment until the problem is resolved.
7. The control panel installation is described in the Installation Manual. Connection to telephone
company provided coin service is prohibited. Connection to party lines service is subject to state
tariffs.
8. Fast PSTN modem must be able to seize the telephone line and place a call in an emergency situation.
It must be able to do this even if other equipment (telephone, answering system, computer modem,
etc.) already has the telephone line in use. To do so, the Fast PSTN modem must be connected to a
properly installed RJ31X jack that is electrically in series with and ahead of all other equipment
attached to the same telephone line. Proper installation is depicted in the figure below. If you have
any questions concerning these instructions, you should consult your telephone company or a
qualified installer about installing the RJ31X jack and Fast PSTN modem for you.
RTTE Compliance Statement
Hereby RISCO Group declares that this Fast PSTN Modem is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
For the CE Declaration of Conformity please refer to our website: www.riscogroup.com.