Pressure Switch And Protection Mode; Controls And Signals - ELMECO B Large BL1 Manual De Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

All models, except the BLarge1 at 220-240V 50Hz, are equipped with an automatic pressure switch. When the slush led
cold drink led and led 1 blink on the electronic board at the same time, it indicates that the pressure switch intervened
to deactivate the compressor; In this condition the freezing will be OFF, to avoid damage to the refrigeration system.
The machine goes into protection mode.
A too high temperature can be caused by:
1. Dirty filter; remove and clean the filter pic.20 pag.65;
2. The machine is located close to a heating source and its internal temperature increases;
3. The air circulation is obstructed.
After solving the problem, the pressure switch will reactivate the compressor automatically.
Remove the plastic filter located on the side panel and clean the radiator with compressed air. This process have to be
done every week or often, it depends from the environmental where the unit is installed.
"slush" mode
functioning indicator;
"Cold drink" mode
functioning indicator;
Do not wash the membrane of the electronic control with abrasive substances or cloths.
The electronic board will keep the settings it had when the machine was switched off.

Pressure switch and protection mode

Condenser cleaning procedure

Controls and signals

Start/stop augers switch;
Mode selector switch;
Product density indicator leds
(min 1, max 3);
Product cooling
activity indicator;
- 23 -
Tabla de contenido
loading

Este manual también es adecuado para:

B large bl2

Tabla de contenido