Care And Cleaning - Mirabelle MIRCRU1812WH Instrucciones De Instalación

sensible sophistication
UNDERCOUNTER INSTALLATION
Setting tool
• Install the faucet to the countertop according
Anchor
M arble
Foam padding • Install the drain to the lavatory according to
NOTE: Do not use adhesives or adhesive
sealants.
Cl amp
• Apply a continuous bead of quality sealant
Apply sealant
Wood Anchor
screw
screw
• C ut out the opening by carefully following the
pencil line traced from the template.
N OTE: The screws and anchors provided • For marble countertops, install the lavatory
should be used on countertops with a
minimum 1" (2.5 cm) thickness. For thinner
countertops, use appropriate anchors and
fasteners (not provided).
For Wood Countertops • Position the lavatory squarely under the
• Mark and pre-drill the wood screw holes at
the locations shown on the template.
• Waterproof any exposed areas of wood.
• Immediately wipe away any excess sealant
For Marble/Stone Countertops
• Position the countertop upside down on foam
padding to protect the surface. Mark and drill • Allow the sealant to set for 30 minutes before
3/8" holes 5/8" (1.6 cm) deep at the
locations shown on the template.
• C onnect and tighten the trap to the drain,
• Use a setting tool and hammer to secure
the anchors.
For All Undercounter Installations
• If the countertop has not been installed, • Run water into the lavatory and check for leaks.
install it at this time.
• C lean up with a non-abrasive cleaner.
• Drill the faucet holes according to the faucet
installation instructions.
3
to the faucet manufacturer's instructions.
the drain manufacturer's instructions.
to the top surface of the lavatory rim where it
will contact the countertop.
CAUTION
Risk of persona l injury or
product da ma ge.
Handle with care. Product can break,
chip or cause injury if handled carelessly .
Get help lifting the lavatory .
to the countertop with the clamps and screws
provided. For other countertop materials,
refer to the countertop manufacturer's
instructions for recommended fasteners.
cutout before tightening the clamps. Draw
the lavatory rim up against the countertop
until it is snug. Do not overtighten.
and fill any voids as needed.
proceeding.
and complete the water supply connections to
the faucet according to the instructions
packed with the faucet.
sensible sophistication

CARE AND CLEANING

• To keep your lavatory looking new, make sure • Stubborn stains, paint, or tar can be
you rinse it out thoroughly after each use.
CAUTION
Risk of product da ma ge.
DO N OT use strong abrasive cleaners, as
they will scratch and dull the surface.
4
removed with turpentine or paint thinner.