Genesys Irid 400 RGB Manual De Instrucciones página 4

All manuals and user guides at all-guides.com
Fan controller for Irid 400 PC case.
Instruction of use
NOTE: The controller is preinstalled and ready to use, once connected to the power supply. The battery compartment of the
remote has a removable plastic tab to isolate the battery power. Remove the plastic tab (by pulling it out completely) to begin
using the controller.
Overview of the controller:
POWER – Connect this cable to the output cable of the power supply units, using a MOLEX 4-pin 12 V connector. A MOLEX 4-pin
to SATA interface adapter is included.
RESET SW – This receptacle can also be wired to the case front panel RESET switch; use a 2-pin cable. It is not factory connected;
the controller does not require wiring to work since it can be operated with the remote.
DATA – This cable terminates with two plugs:
(a) PWM: Can be connected to a compatible PWM 4-pin power output connector on the main board (use the main board user
guide to check compatibility, as the power output connector may use PWM or DC power). Enables BIOS control over the fan speed.
If not connected, the fans operate as set by the remote or the controller.
(b) ARGB: A 3-pin 5 V plug. Connected to a compatible power output connector on the main board (use the main board user guide
to check compatibility), the LED lighting of the fans can be controlled by the BIOS or motherboard software tools. Supports Asus
Aura, MSI Mystic Light, and more.
FAN 1-8
6-pin fan power receptacles. To expand the product with more fans, connect the fans to the receptacles, side by side. Do not leave
any unused power receptacles between the connected fan plugs.
The controller is compatible with Genesis Irid 400 fans for the Irid 400 case. Compatibility with other 6-pin power connector fans
is not guaranteed (even if their connections match those of the controller).
Wiring an incompatible fan may result in failure of the fan and/or controller.
LED
The "LED" receptacles support LED strips with ARGB A 3-pin 5 V connectors.
Controller panel buttons
- LED SPEED changes the lighting colour change rate
- MODE selects the lighting colour mode
- FAN SPEED adjusts the fan speed
EN
PL
DE
ES
CZ
SK
RO
HU
BG
RU