Antenna Assembly - Winegard FreeVision Manual De Instrucciones

Antenna Assembly

1
Lift the forward elements until the holes in the elements align.
2 With the holes lined up, install the UHF elements by inserting the
threaded posts into the holes in the forward elements. The threaded posts
should extend down towards the body of the FreeVision
Thread the supplied 10-32 hex flange nuts on the back of the threaded
3
posts. Do not tighten at this time.
4 Remove and dispose of the rubber boot on the matching transformer.
5 With the logo facing up, thread coaxial cable through the bottom of the
FreeVision antenna. Connect the coax cable to the matching transformer
(A). Insert the coaxial cable and matching transformer into the installation
place (B).
A
Installation Place for
Matching Transformer
1
All manuals and user guides at all-guides.com
antenna.
®
Matching Transformer
B
Coax Cable
Antenna Assembly, Cont.
6
Then, slide one of the forks of the matching transformer between the
two forward elements on the threaded post. Repeat this process for the
other post. Tighten the nuts, making sure the matching transformer is still
connected.
7
Remove the backing from the 'HD' label, and carefully place the label
over the front of the UHF element so that it covers the center block of
the elements.
8 Check that you are within a 35 mile range of the stations that you want to
receive. For a listing of likely channels available in your area, go online to
dtv.gov/maps.
9 Position the antenna toward the broadcast tower for optimal reception. For
most locations, stations will only come from one or two directions. If the
compass headings are similar (<30° apart), the FreeVision antenna can be
aimed between the two areas and receive signals from each location.
10 Run a channel scan. If not satisfied with the channels found, try
repositioning the antenna and running another channel scan.
Forward Elements
HD Label
2