PEERLESS Mounts SUT632P Instalación Y Ensamblaje página 7

Attaching Adapter Plate to Display using VESA 200 x 200 and VESA 200 x 100
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can
cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
Begin with longer length screw, hand thread through multi-washer, adapter plate and spacer in that order into
2
display. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into the display, select a shorter length screw. Repeat for remaining
mounting holes and tighten screws.
NOTE: Multi-washers and spacers may not be used depending on type of display.
NOTE: For displays with a hole pattern in a pocket, spacers (P or Q) go between adapter plate (B) and display.
200 x 200 VESA PATTERN
DISPLAY
B
MULTI-WASHER
SCREW
MULTI-WASHER
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
WARNING
200 x 100 VESA PATTERN
DISPLAY
B
MULTI-WASHER
SCREW
Notes:
• Multi-washers and spacers may not be
• Use the corresponding hole in the multi-
7 of 38
For displays with a hole
pattern in a pocket,
spacers (P,Q) go between
adapter plate (B) and
display.
used, depending upon the type of display.
washer that matches your screw size.
ISSUED: 09-10-09 SHEET #: 202-9365-4 04-05-11