Troubleshooting - WENKO IMPERIAL Manual Del Usuario

Troubleshooting

Fault when setting up the
Bluetooth connection�
The blue LED is not lit up�
Poor sound when playing
Bluetooth�
The range of the Bluetooth
connection is lower than
normal�
I hear static noises and the
music on my mobile device
is stopped�
There is no sound from the
mirror when a Bluetooth
connection has been set up�
The connection of several
mobile phones and other
Bluetooth devices is not
possible�
Radio reception is poor�
If the device is still not working properly after performing the listed solutions, please
call our customer service department via +49 2103 573-0 for technical support�
Imperial_Buch_080515.indb 27
All manuals and user guides at all-guides.com
Fault
The mirror could still be connected to another Bluetooth device�
Please ensure that the other device is disconnected before setting up a
connection to another device� Once this has been done, coupling can take
place normally. If the connection can still not be established, re-start your
telephone or Bluetooth device�
If the mirror has not been used for a long time, it may have changed over to
standby. In order to reactivate your mirror, keep the
few seconds until the device switches on�
1. After mobile devices have been used with the Bluetooth system, the volume
of the Bluetooth system has not been reset to standard level.
The volume of the mobile device must be set to loud�
2� The output volume of the Bluetooth device itself is low�
Make sure that there are no obstacles between the Bluetooth device and
the mirror�
1. There may be obstacles between your Bluetooth device and the mirror.
Remove all obstacles�
2. The mobile device is too far away from the mirror.
Reduce the distance for optimum performance�
The volume of the mobile device is set to soft� Increase the volume�
The volume of the mirror is set to very soft.
Adapt the volume using the „
Only one connection to a Bluetooth device can be established at a time.
You must first disconnect the currently coupled device before connecting the
next one�
Adjust the antenna�
Possible cause
button pressed for a
" button�
27
03.07.15 08:28