TECshow NAVIGATOR 3+ Manual De Usuario página 6

from one another. This feature is traditionally
referred to as Pan/Tilt invert.
5. Press the Tap/Disp button to switch between
"PL.XX" & "PH.XX". "PL.XX" represents the Low
Byte or Fine channel, generally listed as the Pan
Fine channel and PH.XX represents the High Byte
or Coarse channel, generally listed as the Pan
channel. Set it to "PH.XX" and press and hold
down the MODE button and then tap the SCENE
button that corresponds to the Pan channel of
your fixture. For example, if your fixtures Pan
channel is 1 then you´d press SCENE #1 button.
Please refer to the fixtures DMX chart. If your fix-
ture includes a pan fine channel, press tha Tap/
Disp button so the display reads "PL.XX". Press
and hold down the MODE button and the tap
the SCENE button that corresponds to the Pan
Fine channel of your fixture. For example, if your
fixtures PAn Fine channel is 2 then you´d press
the SCENE #2 button.
6. Press the BANK UP or DOWN buttons to switch
between "TL.XX" & "TH.XX". "TL.XX" represents
the Low Byte or Fine channel, generally listed as
the Tilt Fine channel and TH.XX represents the
High Byte or Coarse channel, generally listed as
the Tilt channel. Set it to "TH.XX" and press and
hold down the MODE button and then tap the
SCENE button that corresponds to the Tilt chan-
nel of your fixture. For example, if your fixtures
Tilt channel is 3 then you´d press the SCENE #3
button. Please refer to the fixtures DMX chart. If
your fixture includes a Tilt Fine channel, press
the Tap/Disp button so the display reads "TL.
XX". Press and hold down the MODE button and
then tap the SCENE button that corresponds to
the Tilt Fine channel of your fixture. For example,
if your fixtures Pan Fine channel is 2 then you´d
press the SCENE #4 button.
7. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display stops flashing. A
flashing Blackout indicator in the LED-display
confirms that the controller is out of Program
mode.
P. 6
Tecshow Navigator 3+ | English version
Delete Joystick Pan/Tilt Assignment
1. Press and hold down the Program button for
approximately 2 seconds or until the PROG
indicator in the LED display flashes. Once the
indicator is ashing, record mode is engaged and
you may release the Program button.
2. Press and hold down the MODE button and
then tap the FINE button. The "Assign" and
"Pan" LED's should illuminate.
3. Select the fixtures that you wish to delete the
joystick Pan/Tilt settings for by pressing the rel-
evant FIXTURES # buttons, 1-12, so the relevant
LEDps illuminate.
4. Press and hold down the MODE button, and the
tap the Auto/DEL button to delete the settings
fot the selected fixtures. All LED´s will flash three
times to confirm that the settings were erased.
5. Press and hold down the Program button for
aproximately 2 seconds or until the PROG indi-
cator in the LED display stops flashing. A ashing
Blackout indicator in the LED display confirms
that the controller is out of Program mode.
Delete Pan/Tilt Joystick Settings
For All Fixtures
1. Flip the Operator power switch to OFF. The
switch is located at the rear of the unit.
2. Simultaneously, press and hold down the Auto/
Del and MODE buttons and flip the power
switch ON. All LED´s will ash three times to con-
firm that the Pa/Tilt settings were erased.