Owens Corning VentSure Instrucciones De Instalación página 3

Step 2
Locate the lower
hole on the wall
bracket (Figure 19)
and fi t the bolt
through the 2
brackets and attach
the nut. (Figure 20)
Step 3
Repeat Step 2 for
the upper hole with
another bolt and nut.
(Figure 21 and 22)
Once both nuts
are secure, tighten
completely with an
adjustable wrench.
Step 4
Repeat all the steps
again for the second
bracket. Then
attach to the solar
panel as described
in the installation
instructions that
came with your
™
VentSure Solar
Attic Exhaust Fan
(Gable or Roof
Mount) or Additional
Solar Panel Kit.
Attach the complete assembly to
your fascia board
Step 5
Find a desired location for the completed
assembly and attach with (4) 1.5"
galvanized screws (not included) or
fasteners appropriate for your fascia
Figure 19
material. (Figure 23 and 24). Once secure,
adjust the panel as desired.
Figure 20
Figure 23
Figure 21
Figure 22
Figure 24
Figure 25
OWENS CORNING ROOFING AND ASPHALT, LLC
ONE OWENS CORNING PARKWAY
TOLEDO, OHIO, USA 43659
1-800-GET-PINK
www.roofing.owenscorning.com
Pub. No. 10017987. Printed in U.S.A. October 2012. THE PINK PANTHER
©1964–2012 Metro-Goldwyn-Mayer Studios Inc. All Rights Reserved. The
color PINK is a registered trademark of Owens Corning. © 2012 Owens Corning.
All Rights Reserved.
The solar panel is most effective when
clean and free of dust, leaves, and debris.
Normally, rainwater will cleanse the solar
panel and keep it operating at peak
effi ciency. If necessary, simply hose off the
solar panel between rain showers.
®
™ &