Etac Molift Partner 255 Manual De Usuario página 10

Molift Partner 255 / www.etac.com
Safety devices
Molift Partner 255 is equipped with several safety
devices, which are intended to prevent damage to
personnel and equipment in the case of incorrect
use.
The lifter has an overload sensor preventing the
lifter to be operated if the load exceeds SWL.
The lifting arm is hinged to prevent the arm and
sling bar from squeezing the user.
The electronics are disabled if overheated. Wait
until the lifter has cooled down before using it
again.
Push handles
Use the push handles to move the lifter.
The lifter shall only be used for movement
over short distances. It is not a replacement
for wheelchair or similar.
Brakes
Rear wheels/castors are equipped with brakes.
Step on lever to lock brakes. Flip up to unlock.
Emergency Stop / Emergency lowering
Emergency Stop
The emergency stop shuts off the power when
pushed in. Turn clockwise to reset (OK to operate
when the green ring is visible).
Electrical Emergency Lowering
Push and hold button for electrical emergency
lowering to lower lifting arm. The electrical emer-
gency lowering function does not work when the
emergency stop is activated.
Manual Emergency lowering
There is an Allen key situated on the top of the
column for the purpose of manually lowering.
Push the Allen key through the hole on the top of
the column, and turn until the patient is lowered
down.
Remember to remove the Allen key from the hole
immediately after lowering.
Contact the Molift service partner if the reason
for the failure causing an emergency lowering is
unknown or if it is a result of failed components
or parts.
10
Electrical
Emergency
lowering
Emergency
stop