Power Source - memorex Rise and Shine Guía Del Usario

AC CONNECTION
Insert the small end of the AC adapter into
the DC IN 12V jack (located on the rear of
the unit). Connect the other end to a wall
outlet having 120V AC, 60 Hz.
AC Adapter, DC 12V Z
NOTES:
• Remove both the DC plug and the AC-
IN plug to disconnect the AC adapter
when not in use.
• Only use the supplied AC adapter
which has the following specs: DC 12V Z
BATTERY INSTALLATION
Two (2) "AAA" size batteries can also be used to
power and/or to provide a backup for the clock
and alarm time for this unit as follows:
1. Open the battery door by pushing in on the
tab, then removing the door.
2. Insert two (2) "AAA" batteries as shown.
Alkaline batteries are recommended for the
longest playing time.
3. Place the battery door back on the compartment.
NOTES:
• The batteries are used to back-up the clock and alarm times when the AC
adapter is disconnected or there is a power failure.
• The battery indicator will blink in the display when there are no batteries or the
batteries are low and need replacing.
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated
in the Battery Compartment. A reversed battery may cause damage to
the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable
and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries
to prevent damage or injury from possible battery leakage.
5. Do not try to recharge a battery not intended to be recharged; it can overheat
and rupture. (Follow battery manufacturer's directions.)

POWER SOURCE

All manuals and user guides at all-guides.com
BATTERY PRECAUTIONS
5
front of unit