Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
FAUCET INSTALLATION
Carefully take out all the parts of the faucet assembly .
- Insert the faucet shank (2), hose end (4) and faucet outlet (3) through the holes of the base plate (5) and sink accordingly.
- From underneath, slide the rubber gasket (6) and faucet shank nut (7) over the end of the faucet shank (2), then tighten faucet
shank nut (7) by hand until it is snug.
- Connect the hose end (4) to the faucet outlet (3). Push the faucet head (1) into the faucet neck. Install the counterweight (8) a
couple of inches from the bottom of the hose on the side closest to the faucet head (1). There should be no slack in the hose and it
should retract freely .
- Connect the water supply lines (not supplied) to the faucet.
Faucet shank (2)
1/2" NPS thread
Base plate (5)
Rubber gasket (6)
Faucet shank nut (7)
Counterweight (8)
All manuals and user guides at all-guides.com
Faucet head (1)
7
Please contact [email protected] or 1-877-333-0098 for further assistance .
Faucet outlet (3)
Sink
Hose end (4)
1/2" FIP water supply
line compatible
(not supplied)
CONGLOMKB .COM
Capítulos
Tabla de contenido
