Uline EPOXY WIRE SHELVING Instrucciones De Ensamblaje
Uline EPOXY WIRE SHELVING Instrucciones De Ensamblaje

Uline EPOXY WIRE SHELVING Instrucciones De Ensamblaje

Idiomas disponibles

Idiomas disponibles

EPOXY WIRE
SHELVING
TOOL NEEDED
Rubber Mallet
Post x 4
INSTALLATION OF SELF-LEVELERS AND OPTIONAL CASTERS
Figure 1
Figure 2
PAGE 1 OF 6
1-800-295-5510
uline.com
Shelf x 4
TO INSTALL SELF-LEVELERS
NOTE: If installing casters, do not install self-levelers.
1.
Make sure post is positioned as shown. (See Figure 1)
2. Insert self-leveler into open end of post.
3. Use a rubber mallet/hammer or tap on ground until self-leveler slides
into post.
4. Repeat steps 1-3 for other posts.
TO INSTALL OPTIONAL CASTERS
1.
Make sure post is positioned as shown. (See Figure 2)
2. Engage the wheel brakes to keep casters from rolling during
assembly. Use a rubber mallet to tap caster stems into posts.
(See Figure 2)
3. Repeat steps 1 and 2 for other posts.
PARTS
Shelf Support x 16 Sets
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Self-Leveler x 4
0221 IH-3818
Tabla de contenido
loading

Resumen de contenidos para Uline EPOXY WIRE SHELVING

  • Página 3: Herramienta Necesaria

    800-295-5510 uline.mx ESTANTERÍA DE ALAMBRE EPÓXICO HERRAMIENTA NECESARIA Mazo de Hule PARTES Soporte de Repisa x Set de 16 Poste x 4 Repisa x 4 Autonivelador x 4 INSTALACIÓN DE LOS AUTONIVELADORES Y LAS RUEDAS OPCIONALES PARA INSTALAR LOS AUTONIVELADORES NOTA: Si se instalarán ruedas, no instale autoniveladores.
  • Página 4: Ensamble De La Unidad

    4. Determine la altura de la siguiente repisa, inserte a presión los soportes y después agregue y asegure la repisa. Repita el Paso 4 para agregar las repisas restantes. (Vea Diagrama 6) Diagrama 6 800-295-5510 uline.mx PAGE 4 OF 6 0221 IH-3818...

Tabla de contenido