4Checking The Channel Storage Space Settings - Ecom Instruments Ex-PMR 1000 Instrucciones De Uso

Operation
Press PTT and hold for 2 seconds
Press PTT one time
Press PTT two times
Press PTT three times
Press PTT four times
Press PTT five times
Press PTT six times
Press PTT seven times
Press PTT eight times
Press PTT nine times
Please observe:
In order not to select any pilot tone, select the pilot tone number "0". Press PTT and hold it
for approx. 2 seconds, until a one-second tone sounds.
If PTT is pressed more often than 9 times, a warning tone sounds and no value is selected.
7. The respective signal tone of the selected number sounds after 2 seconds.
8. The setting is completed by pressing the monitor key.
The green LED display flashes two times.
9. Pressing the Monitor key again confirms the signal tone of the selected number.
10. Program another channel just the same as in the above steps 3-9.
Example: Changing a channel storage space (2) with CTCSS – pilot tone No. 25
1. Select channel storage space 2 in the CTCSS/DCS set mode.
2. Press PTT 2 times to select 2 for the "tens" digit.
3. After 2 seconds, 2 short signal tones confirm that 2 has been selected.
4. Press PTT 5 times to select 5 for the "units" digit. Each time you press it,
a signal tone will sound.
5. After 2 seconds, 5 short signal tones confirm that 5 has been selected.
6. Press the monitor key and the green LED display flashes two times.
7. Press the monitor key again. Two short signal tones will sound and - after a short pause -
5 short signal tones, to confirm the selection of 25.
8.4.4 Checking the channel storage space settings
You can check the settings of your radio unit.
Please observe:
After checking is complete, switch the unit off and back on again, so that it is back in the
operating mode. No signal tone will sound if "0" is selected for the "tens" digit.
1. Turn on the unit while pressing the PTT key. The radio unit goes into the check mode.
2. Select the channel storage space which you would like to check.
3. Press PTT and the signal tone sounds (that is, when channel number 8 is set,
All manuals and user guides at all-guides.com
Number
0
1
2
3
4
5
6
7
8
9
Signal tone
1 second tone
.
..
...
....
.....
-.
-..
-...
-....
31