nomad L112 Manual Del Operador página 9

APPLICATIONS
You may use this product for the following
purposes:
n Charging compatible Nomad 18 volt
Li-ion
and Ni-Cd battery packs.
BATTERY PROTECTION FEATURES
Nomad 18 volt Li-ion battery pack is
designed with features that protect the
Lithium-ion cells and maximize battery
life.
If the tool stops during use, release the
trigger to reset and resume operation. If
the tool still does not work, the battery
needs to be recharged.
CHARGING THE BATTERY PACK
Use only Nomad 18 volt Li-ion and
Ni-Cd battery packs with this charger:
Battery packs for this tool are shipped
in a low charge condition to prevent
possible problems. Therefore, you
should charge them until the green LED
on the front of the charger stays on.
CHARGING A BATTERY PACK
If the charger does not charge
t h e b a t t e r y p a c k u n d e r n o r m a l
circumstances, return both the battery
pack and charger to your nearest
Authorized Service Center for electrical
check.
■ Charge the battery pack only with the
charger provided.
■ Make sure the power supply is normal
household voltage, 220V-240V~50Hz,
AC only.
■ Make sure the latches on each side
of the battery pack snap into place
and the battery pack is secured in the
charger before beginning operation.
■ Connect the charger to the power
supply.
■ Place the battery pack in the charger
aligning raised rib on the battery pack
with the groove in the charger.
■ Press down on the battery pack to
be sure contacts on the battery pack
OPERATION
engage properly with contacts in the
charger.
NOTE: After charging is complete, the
green LED will remain on until the bat-
tery pack is removed from the charger
or charger is disconnected from the
power supply.
■ The battery pack will become slightly
warm to the touch while charging.
This is normal and does not indicate
a problem.
■ Do not place the charger and battery
pack in an area of extreme heat or cold.
They will work best at normal room
temperature.
NOTE: The charger and battery pack
should be placed in a location where
the temperature is more than 10°C but
less than 38°C.
■ When batteries become fully charged,
unplug the charger from the power
supply and remove the battery pack.
■ To remove the battery pack from the
charger, depress the latches on each
side of the battery pack.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the
batteries in the battery pack will become
hot. You should let a hot battery pack cool
down for approximately 30 minutes before
attempting to recharge.
8