Rimax Baby CYBER MAX RB212 Manual De Usuario página 17

User manual
Wireless Receiver
Front Controls
1. Receiver Antenna – Receives & Sends signals to or from the Cameras*.
2. Power / Audio Level LEDs – The Green
LED indicates the Receiver Power is ON or
OFF. The Red LED's indicate the Audio Levels
(Low to High).
3. LCD Screen – Displays video from the
Camera.
4. MENU Button – Press to Access the Receiver
Menu. Press the button again to exit.
5. Navigation Controls / OK Button
– Use the controls in Viewing Mode and Menu
Modes:
Viewing Mode: The following controls are
used while watching live video from the
camera:
- Press the UP/DOWN "" arrows to
Increase or Decrease the volume.
- Press the LEFT " " arrow to view cameras*
in automatic switching mode.
- Press the RIGHT " arrow to switch between
the diff erent cameras.
Menu Mode: Use the UP/DOWN/LEFT/RIGHT
"" arrows to navigate in Menu Mode.
Press the OK Button to confi rm the menu
selection.
6. SCAN Button – When the Scan button is pressed, the LCD Screen is turned off and the system continuously
scans all available cameras while the monitor is dark. The SCAN feature can be used for the following two
reasons: (1) To prevent the user from being disturbed (i.e. when sleeping) by the bright LCD screen, or (2)
To conserve battery power. If audio is detected above the preset audio trigger level on the Camera(s)*, the
Receiver will beep and display the triggered Camera. The receiver will return to Scan mode about 5 seconds
after the Alarm has completed. Press any button except "OK" on the front panel of monitor will exit Scan
Mode.
7. Speaker – Produces the sound transmitted from the Cameras*.
8. Belt Clip / Wall Mount – Use the belt clip to easily carry the Receiver with you. Use the Mount hole to
hang the Receiver on a wall (using a screw – not included).
9. Stand – Flip the stand out to place the receiver on a fl at surface (such as a table or countertop). Alternatively,
place the receiver in the Receiver Cradle.
EN
17
Cyber Max RB212
* You must have more
than one camera
confi gured on the
system when using
1
functions that require
more than one camera.
2
3
4
5
6
7
8
9