Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND OPERATING INSTRUCTIONS
WATER SUPPLY (COLD WATER ONLY)
Only draw water through the unit. For use with cold water supply only. Water hose
must be at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not
fall below 2 GPM (gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can
be determined by running the water for one minute into an empty 5-gallon (19 L)
container.
• Never use the pressure washer to draw in water contaminated with
• Dirt in the water inlet will damage the unit. To avoid this risk, we
recommend checking the water filter (located inside the water inlet. To
• Always prevent debris from being drawn into the unit by using a clean
water source and an additional accessory water filter if required.
• To prolong the life of the unit, rest the unit for 5 minutes after every 30
1
Attach the crank on the side of hose reel
on the top of the washer.
3
Attach gun holder and power cord
bracket.
34
All manuals and user guides at all-guides.com
CAUTION
solvents (e.g. paint thinners, gasoline, oil, etc.).
clean it out see Maintenance section).
minutes of use.
2
Insert the tip of the hose connection
to assemble with the gun and turn the
socket to fix both parts.
4
Insert choice of wand to the gun and
twist ¼ turn to lock in position.
Tabla de contenido
