Kicker CX.1 Serie Manual Del Propietário página 3

VERTICAL MOUNTING
amplifi er side panel
hex screws
Wiring: Disconnect the vehicle's battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24" (60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle's chassis. Adding an additional ground wire of this same gauge (or larger) between the
battery's negative post and the vehicle chassis is recommended.
The CX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the CX
amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO". Either input
method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to
another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
core conductor
source unit
high-level speaker
outputs
+
–
2012 CX Mono Amps Rev I.indd 3 2012 CX Mono Amps Rev I.indd 3
All manuals and user guides at all-guides.com
to amplifi er
+
–
shield
+
KICKER ZISL (optional)
OR
source unit high-level
speaker outputs
–
double-slotted
bracket
to amplifi er
3
6/22/2012 2:32:29 PM 6/22/2012 2:32:29 PM