Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
*D-1103*
D-1103
(F)19-R & (F)19-V
Key-In Lever & Key-In-Knob Drilling Template
1. For doors with existing ANSI cutout (2-3/4" backset x 5/8" stop), fold template where shown and
center over 2-1/8" diameter hole. For non-fire rated Rim applications with 2-3/8" backset (of 2-1/8"
diameter hole) must use 565 strike, surface mounted for 1/2" stop.
2. For blank doors, mark horizontal C at 40-5/16" to finished floor and align template with folded tab
L
against stop face.
3. Prepare door as specified.
NOTE:
For Rim devices, insert tailpiece guide into
cross-hair on back of device with proper
orientation as a guide for the trim actuator shaft.
Customer Service
1-877-671-7011
SEE
NOTE
© Allegion 2014
Printed in U.S.A.
D-1103 Rev. 01/14-c
www.allegion.com
TOP
RHR
7/8"
4-1/2"
DEVICE REF C
L
40-5/16" TO
FINISHED FLOOR
(PER ANSI A115.2)
2-1/8" DIA.
ANSI
DOOR
PREPARATION
TAP #10-24
(2 HOLES
FOR F-19-R
TOP
ONLY)
LHR
BACKSET
(REFER TO
DEVICE
INSTRUCTIONS)
5/8"
2-1/8"
DRILL 7/16"
DIA. HOLE
THRU
Manuales relacionados para Falcon 19-R
Resumen de contenidos para Falcon 19-R
- Página 1 *D-1103* BACKSET (REFER TO D-1103 7/8” (F)19-R & (F)19-V DEVICE INSTRUCTIONS) 5/8” Key-In Lever & Key-In-Knob Drilling Template 1. For doors with existing ANSI cutout (2-3/4” backset x 5/8” stop), fold template where shown and center over 2-1/8” diameter hole. For non-fire rated Rim applications with 2-3/8” backset (of 2-1/8”...
- Página 2 (Consulte 22mm (7/8”) las instrucciones del dispositivo) DISPOSITIVOS (F-)19-R &(F-)19-V 16mm (5/8”) CON LA LLAVE EN LAPALANCA O LA PERILLA 1. Para puertas con un corte ANSI (Distancia del plano de la pared a la pestillo de 7cm (2-3/4”) x tope de 114mm (4-1/2”)