Idiomas disponibles
Idiomas disponibles
Worktable with Tubular Base
Step 2 - ttach crossbrace subassembly to legs.
• On legs, measure and mark desired height*
of crossbrace subassembly.
• Insert legs.
• Snug the set screws* in the appropriate
threaded hole in castings (see below).
*
To meet NS standards:
Either the supplied NSF set
screw caps must be
installed over all exposed
set screws, or exposed set
screws must be filled with
silicone sealant.
Step 3 - ttach tabletop.
• Turn tabletop upside-down (take care not to scratch the finish).
• Turn crossbrace subassembly upside-down and insert top of
each leg into each tabletop gusset.
• Tighten all screws.
*
To meet NS standards:
Either the supplied NSF
set screw caps must be
installed over all
exposed set screws, or
exposed set screws
must be filled with
silicone sealant.
NSF set
screw cap
ssembly
is complete.
eagle Foodservice equipment, eagle Mhc, specFAB, and retail Display are divisions of eagle Group. ©2016 by the eagle Group
ASSEMBLY INSTRUCTIONS
leg
threaded
hole in
casting
for leg
set screw
NSF set screw cap
tabletop
gusset
set screw
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S. . • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
crossbrace
leg
subassembly
6˝
Level table with
Level table with
adjustable feet.
adjustable feet.
*
To meet NS standards:
ttach crossbrace
subassembly 6˝
from floor.
(End)
