Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing/Replacing the lamp
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need you need one PAR-56 pressed-glass lamp with up to max. 300 W.
Procedure:
Step 1: Remove the colour filter frame.
Step 2: Please remove the fixation ring by pressing it together.
Step 3: If replacing the lamp, remove the old lamp from the spot and remove the lamp socket.
Step 4: Attach the lamp to the socket and insert the lamp into the housing.
Step 5: Fix the lamp with the fixation ring.
Step 6: Attach the colour filter frame.
The lamps need to be preheated in order to protect them. Please adjust the filament preheat of your dimming
pack so that the coiled filament glows slightly.
Overhead rigging
Optional accessories:
EUROLITE TH-90 theatre-hook for 50mm pipe
Safety-rope 40cm x 3mm up to 10kg
Safety-rope 90cm x 3mm up to 10kg
Safety-rope 140cm x 3mm up to 10kg
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Remove the styrofoam ring at the tube rear before operating this device!
Always install the filter frame bevor operating this device!
CAUTION!
No. 58000720
No. 58010120
No. 58010130
No. 58010135
14/31
42000420_V_1_0.DOC
Tabla de contenido
