Safety Instructions For All Operations - Worx WX739 Manual Original

paper clips, coins, keys, nails, screws or other small metal objects, that can
make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery; avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the battery may cause irritation
or burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.

SAFETY INSTRUCTIONS FOR ALL OPERATIONS :

Safety warnings common for grinding, sanding, wire brushing, polishing, carving or
abrasive cutting-off operations:
a) This power tool is intended to function as a grinder, sander, wire brush,
polisher, carving or cut-off tool. Read all safety warnings, instructions,
illustrations and specifications provided with this power tool. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious injury.
b) Do not use accessories which are not specifically designed and recommended
EN
by the tool manufacturer. Just because the accessory can be attached to your power
tool, it does not assure safe operation.
8
c) The rated speed of the accessories must be at least equal to the maximum
speed setting marked on the power tool. Grinding accessories running faster than
their rated speed can break and fly apart.
d) The outside diameter and the thickness of your accessory must be within
the capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately controlled.
e) The arbour size of wheels, sanding drums or any other accessory must properly
fit the spindle or collet of the power tool. Accessories that do not match the
mounting hardware of the power tool will run out of balance, vibrate excessively and
may cause loss of control.
f) Mandrel mounted wheels, sanding drums, cutters or other accessories must
be fully inserted into the collet or chuck. If the mandrel is insufficiently held and/
or the overhang of the wheel is too long, the mounted wheel may become loose and be
ejected at high velocity.
g) Do not use a damaged accessory. Before each use inspect the accessory such
as abrasive wheels for chips and cracks, sanding drum for cracks, tear or
excess wear, wire brush for loose or cracked wires. If power tool or accessory
is dropped, inspect for damage or install an undamaged accessory. After
inspecting and installing an accessory, position yourself and bystanders away
from the plane of the rotating accessory and run the power tool at maximum
no-load speed for one minute. Damaged accessories will normally break apart during
this test time.