Setting The Direction Of Rotation - Superrollo TWIRL Instrucciones De Uso

i
8. Charging the battery (7)
(1)
(12)
i
9. Assembly
e)
(3)
a)
c)
(2)
(14)
(1)
(14)
(15)
(7)
(8)
(9)
b)
(4)
d)
(4)
(12)
(13)
Charging process:
1.
Insert the charging plug (11) of the charger (5) fully into the charging socket (9) of the
battery (7).
2. Insert the power plug of the charger (5) into a mains socket. Subsequently the indicator
light (8) on the battery (7) will light up red.
3.
The battery (7) will be fully charged after approx. 4.5 hours and the indicator light (8)
will turn green.
NOTE
In order to obtain maximum battery (7) lifetime, the battery (7) should not be kept
permanently connected to the charger.
4. Disconnect the charger from the mains and subsequently remove the charging plug from
the charging socket (9) as soon as the indicator light turns green.
5. Switch the reversing controller (12) to the central position in order to avoid unintended
movement.
6.
Finally slide the battery (7) back into the awning crank (1) housing until you feel it
engage and it connects flush to the housing.
NOTE
When you want to re-charge the discharged battery (7), you can pull it out of the awning
crank housing by means of pressing the two retaining springs (15) together.
1.
Put the two crank rods (2/3) together and secure the connection with the connection
clip (4) provided, (see figures "a" + "b")
2.
Attach the lower crank rod (2) to the electrical awning crank (1) and secure it in the
same way with one of the enclosed connection clips (4), (see figure "c" and "d").
3.
Finally, hook the crank rod hook into the eyelet of your awning drive (see figure "e").
i

10. Setting the direction of rotation

1.
You can change the direction of rotation at any time by means of pressing the reversing
controller (12) on either the right or left-hand sides of the housing.
IMPORTANT
If the on/off switch (13) is pressed, the reversing controller (13)
cannot be actuated.
2.
In order to lock the electrical awning crank (1) in place, the reversing controller (12)
must be slid to the central position.
i
11. Operation
1.
Hold the electrical awning crank (1) firmly with both handles (14).
2. Ensure that the reversing controller (12) is set to the desired direction of rotation.
3.
The electrical awning crank (1) can be switched on by lightly pressing and holding the
on/off switch (13).
IMPORTANT
◆ Initially only press the on/off switch (13) lightly, in order to get a
feel for the power of the equipment.
◆ Please approach the end positions of the awning with care, as moving
too quickly can lead to severe jolting.
4. Pay attention to the speed. This can be infinitely adjusted depending on how far the on/
off switch (13) is pressed in:
Light pressure = Slow speed.
Strong pressure = High speed.
NOTE
◆ The crank rod (2/3) can be disconnected from the electrical awning crank (1) at
any time by releasing the connection clip (4).
◆ We recommend removing the awning crank (1) from the awning after each use in
order to prevent unintended operation (for example by children playing with it).
EN
7