Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
4. To end the milk frothing process turns the steam knob clockwise. Take out
the steam tube from the cup with milk. Never take the steam tube out of the
cup if the steam knob is not turned off. Hot steam may cause injuries and
scalds.
5. After milk frothing it is advised to put the steam tube into a cup with clean
cold water and rinse the system. After the steam tube is immersed in the cup
with water turn the steam knob anti-clockwise. After few seconds, turn off
the steam flow by turning steam knob clockwise.
6. Turn off the milk frothing mode by press the steam switch.
IMPORTANT:
•
In choosing the size of jug, it is recommended the diameter is not less than
70±5mm, and bear in mind that the milk increases in volume by 2 times,
make sure the height of jug is enough.
•
Never turn the steam control button rapidly, as the steam will accumulate
rapidly in short time which may increase the potential of the risk of explosion.
•
During operation, if the blue indicator is extinguished, you should turn the
steam control left wise. Press coffee switch and pump water, and then wait
for until the blue light is illuminated permanently and turn the steam control
knob in anti-clockwise, the steam will come out again.
•
Clean steam outlet with wet sponge immediately after steam stops
generating, but care not to hurt!
Preparation of Cappuccino
You get a cup of cappuccino when you top up a cup of espresso with frothing
milk.
1. Prepare espresso first with container big enough according to the part
"Make Espresso Coffee"; make sure that the steam control knob is turned off
at right.
2. Froth the milk as instructed on "Frothing milk".
3. Pour the frothed milk into the espresso prepared; now the cappuccino is
ready. Sweeten to taste and if desired, sprinkle the froth with a little cocoa
powder.
Clean and Maintenance
Rinse the coffee maker's water system
1. Turn device on by pressing the ON/OFF switch. Coffee maker will start to pre-
heat, LED will blink.
2. When coffee maker is ready, the LED will stop blinking and turns on.
3. Place the filter holder in the mounting point to rinse the water system of
6
Instructions for use
Tabla de contenido
