Clock Setup; Setting The Time - XD COLLECTION P308.23 Serie Manual Del Usuario

CLOCK SETUP:

Connect the included cable to the alarm clock and then connect it to a wall
adapter.
The clock display will turn on when the clock is connected to power.
1. Default time display 12-Hour, press and hold the [ DOWN ] button to toggle
between the 12-hour and the 24-hour clock.
2. In time mode, short press [ UP ] button to switch display mode, dP-1, dP-2,
dP-3 .
3. In time mode, press [ UP ] button 2 seconds enter power saving setting
mode, display"--Sd" means power saving mode in off status ; short press [
DOWN ] button ,display""onSd" means power saving mode on. In power saving
mode, the LED display will turn off after 10 seconds, press any button or tap on
top of the alarm clock to turn on the LED display. Short press [ DOWN ] button
again to turn off the power saving mode, press [ SET ] or [ UP ] will return to
its default display mode.
4. In time mode, short press [DOWN] button to adjust LED display brightness,
low brightness,medium brightness,high brightness.

SETTING THE TIME

1. Press the [ SET ]button until the time is displayed.
2. Press+hold the [ SET ]button to set the time. The time hours will begin
flashing. Press the [ UP ] and [ DOWN ] buttons to adjust. The dot in the upper
left corner of the display will appear when the hour is in PM.
3. Press [ SET ]to save the hour setting. The minute digits will begin flashing.
Press the [ UP ] and [ DOWN ] buttons to adjust,and press [ SET ] to save.The
clock will return to its default display mode.
ALARM TIME FUNCTION
1. In time mode, short press [ SET ]button enter alarm mode, display "-- --"
means alarm in off status.
2. Press [ UP ] or [ DOWN] to turn on the alarm function, 12-Hours default,the
dot in the lower left corner will display when the alarm is turned on.