Panacom PA-7018 Manual Del Usuario página 6

08".Press the UP or DOWN buttons to adjust the con-
trast level step by step.Press the BACK/SET to save it
and the settings have been finished.
Total levels:16 levels (from 00 -15).
4. Setting PABX code
Press DEL button and hold it for 3 seconds and then the
LCD will display "–".
Press the UP or DOWN buttons to select the PABX code
and press BACK/SET to save and exit.
Note:
After setting the PABX CODE,when calling back the in-
coming calls,the phone will dial out the numbers with the
PABX Code automatically
F. The solutions of Simple problems
a. No display screen:
Reasons: No batteries or reversed batteries or batteries
in bad condition.
Solutions: Install or replace batteries.
b. No dailing sounds:
Reason 1:The user's telephone route has a fault itself.
Solution: Contact the Local Telecomunication Depart-
ment to keep in good repair.
Reason 2: The end-route looses contact or cut off route.
Solution: Put through the route after checking it.
c. No display main calls number:
Reason: The local Telecomunication Department do not
put through the service.
Solution: Contact the Telecomunication Department and
apply for the caller ID service.
Pg. 6