Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
SPECIFICATIONS
Max. flow rate: 2.2 GPM (8.3 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Compression cartridge
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply
valve under the sink or at the
main water supply, disconnect
the supply line, and remove old
faucet.
Clean and dry surface area
where new faucet will be
mounted.
2. Cover thread connection of
stub-out with PTFE pipe tape
(wrapped clockwise) or pipe joint
compound.
OPERATION INSTRUCTIONS
This faucet is a single temperature faucet. Depending on
what you hooked the faucet to, it will either be all COLD or
all HOT water.
Turn faucet handle to the left to turn on, to the right to turn
water off.
CARE AND MAINTENANCE
Clean periodically with a soft cloth. Avoid abrasive cleaners,
steel wool, and harsh chemicals as these will dull the finish
and void your warranty.
1
2
SPECIFICATIONS
Brass waterways
Manufactured to include no more than 0.25% weighted
average lead content on wetted surfaces
Total weight of item: 0.474 lbs.
3. Thread faucet onto stub-out
or water supply line. Do not
overtighten.
Turn water supply or shut-off
valve back on and check for
leaks.
4. Important: After installation is
completed, remover aerator.
Turn on water supply and allow
hot or cold water to run for at
least one minute. While water
is running, check for leaks.
Replace aerator. Tighten nuts
slightly to stop minor leaks. If
problems persist, refer to
troubleshooting chart.
To get a blended temperature, you must have two spigot
faucets installed, one hot and one cold. Place plug in the
sink basin, turn on the hot and cold water to fill the basin.
Adjust the water temperature in the basin by adding more
or less hot or cold water.
2
3
4
www.homewerksww.com
Tabla de contenido
