Idiomas disponibles
Idiomas disponibles
EN
Mounting and operation
Attention: The installation of electrical devices must be done by an authorized
installer..
1. Designed to easily connect to a switchboard of electrical switches; just set the timer on the
1. Designed to easily connect to a switchboard of electrical switches; just set the timer on the
DIN rail and press it until it clicks into place "Click" To remove it, push the latch on the bottom
DIN rail and press it until it clicks into place "Click" To remove it, push the latch on the bottom
of the timer and release.
of the timer and release.
2. Once the connections have been made, it is necessary to select through the controls
2. Once the connections have been made, it is necessary to select through the controls
control the type of operation desired and the activation time of the light load.
control the type of operation desired and the activation time of the light load.
a. Staircase has automatic recognition for the 3 and 4 wire connection.
b. Put the switch in the position
c. Put the switch in the opposite position to work as a timer countdown.
d. Select the desired time (between 30 seconds and 20 minutes) of turning on the
illumination.
e. Press the switch to activate the countdown. The light will turn on and off
automatically after the set time.
f. The total current of the neon switch must not exceed that mentioned in specifications.
If a neon works with a current of 1mA, it should not connect more than 30 neon switches
to the timer.
g. For switches without neon, you can connect as many as you want.
3. When the switch is in countdown mode, there will be no response through:
a. Pressing the connected switch.
b. Turning the time command to another period.
:
so that the lighting is always on.
KSC-03
Staircase time switch
-8-
