AKRO-MILS ULTRA/Deck Instrucciones De Ensamblaje

Assembly Instructions
ULTRA/Deck Structural Foam Platform Truck
™
24" x 48" & 30" x 60"
STEP A
1. Place deck upside down
on a table or floor.
2. Fit socket stiffeners
into groove. Note: A nut
is welded to each socket.
Face the nuts toward the
middle of the deck.
3. Place the swivel
casters on the deck, at
the socket end.
4. Place the rigid casters
at the opposite end.
5. The top plate of each
caster is centered over
the stiffener tube and lined
up with the four lag
shields (pre-installed).
6. Place a flat washer over
each lag screw.
7. Place a lag screw and
torque down through the
slot in each caster.
Four screws required per
caster. Apply an even
amount of torque to
7
each screw.
STEP B
1. Turn the deck over onto its
casters and insert the handle
into the sockets.
2. Thread the 3/8-16 jam nut
onto the 3/8-16 x 1" hex head
cap screw. There are two
of each.
3. Thread the hex head cap
screws into the nut welded
to each socket. Tighten
securely.
4. Adjust the jam nut so that
the hex head cap screw
can be tightened securely.
Complete installation by
seating jam nut against the
welded nut.
6
4
5
5
1
TOOLS:
HERRAMIENTAS:
OUTILS :
GOGGLES / GAFAS /
LUNETTES DE SÉCURITÉ
9/16" END WRENCH
LLAVE MECÁNICA DE 9/16 PULG.
3
CLÉ PLATE DE 9/16 PO
PARTS:
PARTES:
PIÈCES:
2
SWIVEL CASTERS
RUEDAS GIRATORIAS
ROULETTES PIVOTANTES
2
16
LAG SCREWS
TORNILLOS GOLOSOS
TIRE-FOND
16
LAG SHIELDS
RECEPTÁCULOS PARA TORNILLOS
INSERTS DE VISSAGE
16
1
FLAT WASHER
ARANDELA PLANA
RONDELLE PLATE
2
SOCKET STIFFENERS WITH WELDED NUT
REFUERZOS DE CUBOS CON TUERCA SOLDADA
RAIDISSEURS À MANCHON AVEC ÉCROU SOUDÉ
1
DECK
PLATAFORMA
PLATEAU
1
HANDLE
AGARRADERA
GUIDON
2
3/8 HEX HEAD CAP SCREW
TORNILLO DE CABEZA HEXAGONAL DE 3/8
VIS À TÊTE HEXAGONALE DE 3/8
2
3/8 JAM NUTS
4
2
CONTRATUERCAS DE 3/8
CONTRE-ÉCROUS DE 3/8
Instrucciones de ensamblaje
Carretilla con Plataforma de Espuma de
Plástico Estructural
Instructions d'assemblage
Chariot à plateau en mousse structurée
au en mousse structurée
CORDLESS DRILL WITH NUT
DRIVER BIT 9/16"
TALADRO INALÁMBRICO CON
DESTORNILLADOR DE TUERCAS
DE 9/16 PULG.
PERCEUSE SANS FIL À EMBOUT
TOURNE-ÉCROU DE 9/16 PO
9/16" SOCKET ON RATCHET
TRINQUETE CON CASQUILLO DE 9/16 PULG.
DOUILLE DE 9/16 SUR CLIQUET
2
RIGID CASTERS
RUEDAS RÍGIDAS
ROULETTES FIXES
FLAT WASHER
DECK
HANDLE