Clock And Timers - THOMSON RK200DABCD Manual Del Usuario

Battery Power
• Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove
the batteries when the appliance will not be used for a long period of time, as leaving them in will
cause leakage and subsequent damage to your set.
• Use batteries of the same type. Never use different types of batteries together.
• Do not throw the battery into a fire, or expose it to sunshine or the like.
• If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and thoroughly with clear water and seek medical attention.
Unit power supply (mains 230V/50Hz)
Connect the mains cable plug to the 230V wall outlet.
Warning:
• Before using the unit, check that the local mains supply is compatible with the unit (230V/50Hz).
• Do not plug or unplug the mains cable when your hands are wet.
• When planning not to use this unit for long periods of time (i.e., holidays, etc.), disconnect the plug
from the wall outlet.
• When disconnecting the mains cable from the wall outlet, take hold of the plug; do not pull the cord
in order to avoid shock risks caused by the damaged cable.
Operation
Press the POWER button to turn the unit ON/OFF.
Adjusting the Volume
Rotate the volume knob clockwise to increase the volume.
Rotate the volume knob anti-clockwise to decrease the volume.
Check the display, which will confirm the volume setting.
Mute
Press the MUTE button to the ON position, then the volume is muted and the message "volume muted"
will appear on the LCD display. Press this button to the OFF position to cancel the MUTE function.
(Note: the Volume knob cannot cancel the MUTE function)

Clock and Timers

Setting the Clock and Date
After the unit is plugged into a mains supply or following a mains power failure, the display will show the
current time and date on the LCD display. The unit should be in standby mode to set the current clock.
1. Press the CLOCK button, and "Time Setup" is displayed; press ENTER to confirm, and "Time
Wizard Interval" is displayed.
2. Press /
display will blink.
to set the hour, press ENTER to confirm; the "Minutes" digits on the display will blink.
3. Press /
4. Press /
blink.
5. Press / to set the Year, then press ENTER to confirm; the "Month" digits on the display will blink.
6. Press /
to set the Day, press ENTER to confirm. Press
7. Press /
Setting the Alarm
Note: Check that the radio has the correct time and date before you set an alarm.
This unit may be used as an alarm clock. The Bluetooth device, USB device or FM radio is activated
to play at a preset time.
1. Press POWER to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press ALARM button in shutdown state;
4. "Alarm 1 (or 2) Setup" is displayed. Press the ENTER button to select.
to select "24H" or "12H", then press ENTER to confirm. The "Hour" digits on the
to set the minutes, then press ENTER to confirm; the "Year" digits on the display will
to set the Month, press ENTER to confirm; the "Day" digits on the display will blink.
- EN 6 -
/ "YES/NO" to select and save.