Horizon Global 76183 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Figure 3
CL
3.5''
Figure 4
1. Remove fascia – (a) Using T25 torx bit, remove (4) screws from rear bottom fascia.
(b) Using T25 torx bit and 10 mm socket, remove (1) screw and (1) plastic flange nut from wheel well liner, both sides.
(c) Using plastic trim tools, remove the lower part of wheel well trim by unclipping the tabs from fascia and gently pulling it outward, both sides.
(d) Using T25 torx bit, remove (3) screws located vertically in the upper area behind the wheel well liner and (1) screw behind wheel well trim, both sides.
(e) Open lift gate. Using T25 torx bit, remove (2) round plastic screws near trunk weather seal. Remove rear cargo flooring.
(f) Using panel removal tool, remove scuff plate by unclipping the tabs and pulling it upward. Using 10 mm socket, remove (2) flange nuts from two recessed bumper fascia studs
under scuff plate covered by rubber plug, see Figure 2.
(g) Remove driver side interior panel. Unclip (2) wiring harness if present. Behind insulation material, using 10 mm socket, remove (1) flange nut bumper fascia stud inside the
compartment. Repeat same steps on passenger side but DO NOT remove any wiring harness.
(h) Using plastic trim panel tool, remove the fascia starting at the outer edges near wheel wells, and gently pulling the fascia.
2. Remove bumper beam – Using 16 mm socket, remove (8) M10 factory bolts from bumper beam and cross bar above bumper beam. Return bumper beam and cross bar to owner.
3. Install hitch –Use silicone sealant to seal around the opening on the end panel both sides, see Figure 3. Raise the hitch into position and loosely install (8) existing factory M10 bolts
to the hitch, see Figure 1.
4. Tighten all M10 fasteners with torque wrench to 53 Lb.-Ft. (72 N*M).
5. Trim fascia – Using tape and utility knife, cut a notch in the lower part of fascia as shown in Figure 4. DO NOT cut the wiring behind center lower fascia.
6. Reinstall all fasteners, wiring harness, panels, rubber plugs, scuff plate,, wheel well trim, and fascia removed in Step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2017 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76183, 84183, CQT76183
(8) Existing
factory M10
bolts
2.0''
Bumper end
panel
Rear
Figure 1
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Sheet 3 of 30
Figure 2
76183NP 07-19-17 Rev. A