Installing The Batteries; Using The Remote Control; First Time Installation - Tesla 43T319 Manual Del Usuario

Installing the batteries

Fig.5 NOTE: Pictures are only for reference. Actual items may differ.
Precautions for using the battery
Improper using of the battery will cause leakage. Carefully follow these instructions.
1. Please note the batteries' polarity to avoid short circuit.
2. When the battery's voltage is insu cient which a ect the use range, you should replace it wit ha new
battery. Remove the batteries from the remote control unit if you do not intend to use it for a long time.
3. Do not use di erent types of batteries (for example Manganese and Alkaline batteries) together.
4. Do not put the battery into fire, and charge or decompose the battery.
5. Please dispose batteries abide by relevant environmental protection regulation.

Using the remote control

• Use the remote control by pointing it towards the remote sensor. Items between the remote control and
the remote sensor could block normal operation.
• Do not cause the remote control to vibrate violently. Also, do not splash liquid on the remote control, also
do not put the remote control in a high humidity place.
• Do not place the remote control under direct sunlight which will cause deformation of the unit by heat.
• When the remote sensor is under direct sunlight or strong lighting, the remote control will not work. If so,
please change the lighting or TV's position, or operate the remote control closer to the remote sensor.

FIRST TIME INSTALLATION

After all connections have been made properly, switch on your TV. Insert the main power plug into the wall
outlet, now the red LED light should light up. Press the q button on your remote control to wake the TV up.
The language and country selection will appear on the screen. Use  to select the OSD Language of your
preference. Use  to select the Country and use  again to select the region you are using this TV. This
country/region selection is an important setting, it will set the time zone and will try to sort region channels at
first or in a specific order.
If all settings are made, confirm with OK on your remote control and follow the next steps.
On the next screen, you can select which tuner you like to use and which channels you'd like to search for.
Choose Tuner Type and by pressing  you can choose between DTV, ATV or DTV + ATV (DTV to search
digital broadcasts; ATV to search analogue broadcasts). After you made your selection, press  to proceed
to Digital type. In this menu you can select which input source you would like to use:
• Satellite to receive satellite broadcasts (if you are equipped with a satellite dish)
• DVB-T to receive terrestrial broadcasts (by using indoor or outdoor antenna)
• DVB-C to receive cable broadcasts. (Connection to cable outlet box)
Then the next screen appears depending from the tuner selection you choose.
DVB-S/S2 installation
Satellite Setting
Press  to s elect the satellite your dish is aimed at. Use the  buttons to change settings for your
satellite installation for each specifc satellite.
Channel Search
Press  to highlight the options of choice and press OK to start the channel search.
7
ENG