Maintenance And Cleaning; Maintenance Intervals; Oil Change - Cross Tools CPG 6000 DEV Manual De Instrucciones

Original User manual

6. Maintenance and cleaning

Note:
Make sure that the main switch (fig. 2 no. 12 & 14) is at OFF before you begin maintenance.
6.1.

Maintenance intervals

Maintenance interval
To be carried out depending
on which criteria occurs.
(Period or operating hours)
Element
Inspection (see 6.1.)
Engine
Change
oil
(See 7.2.)
Inspection
(See 7.3.)
Air filter
Cleaning
(See 7.3.)
Cleaning the fuel filter
(See 7.5.)
Adjusting the valve clearance *
Cleaning combustion chamber and
valves *
Checking the fuel line (replace if neces-
sary) *
Exhaust *
* Get this work carried out by authorised personnel.
6.2.

Oil change

Empty the oil as long as the engine is still warm in order to guarantee
a quick and complete drainage.
1. Remove the oil drain screw (fig. 14, no. 18) and the oil cap (fig.
14, no. 15) and drain the oil. Retighten the screw (fig. 14, no. 18)
including a new seal.
2. Fill the engine oil with the recommended quality
(see fig. 6.1) and check the oil level.
Oil fill capacity: 1.65 l (slight deviation possible)
Caution: Prolonged or repeated skin contact with used oil can cause skin cancer.Although the
risk is very low unless you come in contact with used oil on a daily basis, you should wash
your hands with soap and water as soon as possible after coming in
Note:Dispose of the waste oil in an environmentally responsible way. We recommend handing over the waste oil
in a closed container to a local disposal company for recycling.You can find this under, e.g. http://www.wer-
entsorgt-was.de/entsorger_suche.html Do not dispose of the waste oil in the trash or by pouring it out.
6.3. Maintenance of air filter
A dirty air filter limits air flow into the engine. Maintain the air filter regularly to prevent the generator from malfunc-
tioning. If you use the generator is very dusty areas, you must clean the air filter more often. Carry out a visual in-
spection for dirt and damages before every use.
Warning! Never use petrol or solvent with low flash point for cleaning the air filter. It can result
in fires or explosions.Follow the instructions and safety information on the packaging of the
solvent
After the first
Daily
month or 20 h
●
●
●
Cleaning after 100 operating hours
11
Every 3 months Every 6 months
or 50 h or 100 h
●
●
●
14
c
ontact with waste oil.
Every 12 months
or 300 h
●
●
●
27