INKBIRD IBS-M1 Manual Del Usuario página 6

All manuals and user guides at all-guides.com
Inkbird Pro enables you to control more than one
Inkbird product on your phone, including but not
limited to IBS-M1 Wi-Fi Gateway. IBS-M1 app is
specially built for IBS-M1 Wi-Fi Gateway.
You could control the IBS-M1 Wi-Fi Gateway on your
phone with either of them, just choose an app
according to your needs.
3.2 Connect to your phone
1. Register before using the Inkbird Pro app. Select
your Country/Region, enter your e-mail, then a
verification code will be sent to you, enter it to
confirm your identity and the registration is done.
2. Open the app and click "+" to start the connection.
3. Plug in the Inkbird Wi-Fi Gateway, the Wi-Fi button
will flash rapidly by default, confirm it on your app
when promoted, then enter your Wi-Fi password to
connect to wireless network, click OK to connect the
device.
4. Connection succeed.
Note: Please skip Section 3.3 if you have already
connected your Wi-Fi gateway to the Wi-Fi network
successfully, the Section 3.3 is prepared for
customers who have special needs or can not
connect their Wi-Fi gateway in this mode.
3.3 Connect the device in AP mode
If the Wi-Fi gateway is not connected to your phone,
the light of Wi-Fi button will flash rapidly by default.
Press and hold the button for about 5 seconds to
switch to AP mode, the light of Wi-Fi button will
flash slowly in the mode 5 seconds later.
1. Open the app and click "+" to start the connection.
2. Plug in the Inkbird Wi-Fi Gateway, choose the
IBS-M1 Wi-Fi gateway , click "AP Mode" of the right
top corner, check if the light of Wi-Fi button is
6