Troubleshooting - LEGEND FORCE 1005697755 Guía De Uso Y Cuidado

Troubleshooting

Problem Cause
□
The engine fails to
start.
□
□
□
□
□
□
□
The engine runs erratic.
□
□
□
□
□
□
The engine overheats.
□
□
The motor occasionally
skips (hesitates) at
high speeds.
□
The motor idles poorly.
□
□
There is excessive
vibration.
□
□
The trimming
performance is poor.
□
The control lever is disengaged.
The spark plug boot is disconnected.
The fuel tank is empty or the fuel is stale.
The engine is not primed (if equipped with primer).
The spark plug is faulty.
The fuel line is blocked.
The engine is flooded.
The spark plug boot is loose.
The fuel line is blocked or the fuel is stale.
The vent in the gas cap is plugged.
There is water or dirt in the fuel system.
The air cleaner is dirty.
The unit is running with the CHOKE (if equipped)
applied.
The engine oil level is low.
The air flow is restricted.
Spark plug gap is too close.
Spark plug is fouled, faulty, or gap too wide.
Dirty air cleaner.
The spindle wing nuts are loose.
The spindle is damaged.
The trimmer line is too short or worn.
The spindle belt is worn or damaged.
Solution
□ Engage the control lever.
□
Connect the wire to the spark boot.
□
Fill the tank with clean, fresh gasoline.
□
Prime the engine as instructed in the Operation section.
□
Clean, adjust the gap, or replace.
□
Clean the fuel line.
□
Wait a few minutes to restart, but do not prime.
□ Connect and tighten the spark plug boot.
□
Clean the fuel line. Fill the tank with clean, fresh
gasoline.
□
Clear the vent.
□
Drain the fuel tank. Refill with fresh fuel.
□
Clean the air filter.
□
Push the CHOKE knob in.
□ Fill the crankcase with proper oil.
□
Clean the area around and on top of the engine.
□ Adjust the gap to 0.030 in..
□ Adjust the gap to 0.030 in. or replace the spark plug.
□
Clean the air filter.
□ Tighten the wing nuts.
□
See an authorized service dealer.
□ Replace the trimmer line.
□
Replace the spindle belt.
17
Please contact 1-877-527-0313 for further assistance.
HOMEDEPOT.COM