Stanley FATMAX FMHT77652 Manual De Instrucciones página 6

Installing AA Batteries
GB
WARNING:
Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
On the back of the Detector, lift up the battery
1.
compartment door (Figure
Insert two new, high-quality, name brand AA
2.
batteries, making sure to position the - and +
ends of each battery as noted inside the battery
compartment (Figure
Push the battery compartment cover closed until it
3.
snaps in place (Figure
Press to turn the Detector ON.
4.
Check the battery icon (Figure
5.
screen. It should show that the battery is Full.
Full
About 2/3
About 1/3
Batteries need to be replaced.
If you are not ready to use the Detector now, press
6.
and hold
Detector OFF to conserve the batteries.
Using the Detector
The D WALT Digital Laser Detector can be used with
E
or without the detector clamp. When used with the
clamp, the detector can be positioned on a grade rod,
leveling pole, stud, or post (Figure
6
).
B
1
).
B
2
).
B 3
) on the LCD
E
1
Battery Charge Level
for at least 2 seconds to turn the
).
D
Attaching the Detector to the Clamp
Use the alignment holes (Figure
1.
clamp onto the detector (Figure
Turn the attachment knob (Figure
2.
to secure the Detector on the clamp.
Turn the clamp knob (Figure
3.
to open the jaws on the clamp.
Place the clamp on the rod (Figure
4.
detector is positioned at the height needed to work
with the laser.
Turn the clamp knob (Figure
5.
secure the clamp on the rod.
Notice that the Detector's Reference Line is lined up
with the top edge of the clamp (Figure
when you align the Reference Line with a laser beam,
you will use the knob (Figure
and move the Detector up or down, as needed.
Turning the Detector ON
Press to turn the Detector ON.
1.
Make sure all the icons are displayed momentarily
2.
on the front LCD screen (Figure
back LCD screen (Figure
Illuminating the LCD Screen
When the Detector is ON, press
the light on the LCD screen.
NOTE: If after 60 seconds, a laser beam is not
detected or a button is not pressed on the keypad, the
LCD screen will automatically turn off.
Adjusting the Accuracy Setting
By default Accuracy is set at HIGH. Use a lower
accuracy settings when:
• A high accuracy setting is not needed.
• A stable reference level cannot be obtained due to
vibrations.
• Heat haze interferes with the laser beam.
) to guide the
A
8
).
C
1
) clockwise
C 2
) counterclockwise
D 1
) so the
D 2
) clockwise to
D 1
). Later
D 3
) to loosen the clamp
D 1
) and the
A 4
).
A 5
to turn ON/OFF